ConnieLene – KnitDesigner

But HOW to create a Knitted piece to cover a Haarlem Ball – or other spherical object – that is the question?

You need to know the size of your sphere – ball. My first one was 150cm plus a handspan (my handspan).

I began with 8 stitches, increased to 320 stitches by increasing 8 times on every 4th round (more or less). I knitted this on a circular needle and circularly – entirely appropriate for a circular object.

I used 8 ply or double knit yarn on 4mm needles. The length from the top point to 320 stitches should be around 80cm. I have knitted the last of the top section of about 10 cm in k1p1 rib to help the cover to cling well. It is not a good look to have a baggy saggy ball warmer. There is a bit of give and take – because I didn’t knit this first half with only 8 ply (DK) yarns – I included mohair and faux fur fibres and some cotton yarns. So I needed to measure the piece for length as I knitted and adjust the increases and I will have to do the same when I do the decreases. SO this is not a formal pattern – this is a “suck it and see” piece of knitting.

Decreasing will be the increasing process in reverse – except that I will end up with around 32 stitches because the bottom half doesn’t present the full sphere to you as it is set in concrete. This half will still be created on a circular needle, but is not longer knitted circularly otherwise it will not fit over the ball. So back and forth from the centre down (more or less). I will knit the bottom half in garter stitch to assist it to join more easily – it is awkward to join the ball warmer together as I found with the first Haarlem Ball Warmer. I think I will use velcroe on this one – so that it can be joined more easily and removed more easily. It could then live another day as something else maybe.

There are lots of balls to alter however temporarily here in Haarlem, and also in Maastricht, so maybe they are everywhere in the Netherlands and I have received reports of very large balls in California.